Connectors

发布时间：2025-05-02

【Method of Use】
1. Detach the charge intake cover from the charge valve.
2. Set the cap nut in the connector. Then, mount them in the charge intake.
3. Confirm that the connected side of the connector and the charge intake are normal. Afterwards, tighten the cap nut with the spanner etc. Be careful not to over tighten.
4. Use a commercially available tube fitting suitable for the outside diameter of the pipe connector when connecting to the gas introduction pipe of the reactor.

We have two types of connectors, a tube connector for under ordinary pressure and a pipe connector for under increased pressure. The outside diameter of both connectors is 6.0 mm. Each connector is bundled with a cap nut. Please use both connectors according to the situation.

 

上一篇：聚γ-[N，N-双(β-甲硫乙基)氨基]丙基倍半硅氧烷铑配合物
下一篇：西亚试剂:“转基因”食品标识不明显“转”与“非转”欲说还休